Hinkley SWELL Instruction Manual page 9

REMEMBER
to turn o° the power before you begin.
To properly install your ceiling fan, follow the steps below.
Slip the yoke cover, trim ring and canopy onto the
6
downrod. (Fig. 3)
Slide the hanger ball onto the downrod, insert the cross
7
pin through the downrod and tighten. Tighten the set
screw.
Lift ball/downrod/fan into hanger bracket opening.
8
NOTE: The tab opposite hanger bracket opening should fit
in slot on ball. (Fig. 4)
*
IMPORTANT: Take the lead wires and make sure that you
have pulled them all the way through the top of the dawnrod.
Star at the TOP of the downrod and measue 8 in. of lead wire,
and then cut the excess wires o° with wire cutters (not
included).
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the safety
cable from the fan. Loop the safety cable around the wood screw
that was just attached to ceiling joist. Feed the end of the cable
into the clamp and pull as much cable through as possible. Firmly
tighten screw in the clamp. Cut o° excess cable and tighten the
wood screw to ceiling joist.
*
Canopy
Yoke cover
Top of
fan body
Fig. 3
Safety cable clamp
Safety cable loop
Wood screw and washer
Safety cable
Fig. 4
Cross pin
Hanger ball
Set screw
Hook-up (5) wires
Downrod
Trim ring
Wood ceiling joist
| hinkley.com
©2023 Hinkley Lighting, Inc.
07