Preparation; Installing The Hanging Bracket - Hinkley ATOM Instruction Manual

PREPARATION

PREPARATION:
Verify you have all parts before beginning the
installation. Check foam insert closely for missing
parts. Remove motor from packing. To avoid
damage to finish, assemble motor on soft padded
surface or use the original foam inset in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE AS
THIS COULD RESULT IN SHIFTING OF
MOTOR IN DECORATIVE ENCLOSURE.

INSTALLING THE HANGING BRACKET

WARNING: To avoid possible electrical shock, be sure electricity is
turned off at the main power box before wiring. All wiring must be
in accordance with National and Local Electrical Codes and the
ceiling fan must be grounded as a precaution against possible
electric shock.
Locate ceiling joist where fan is to be mounted, being sure
1
location agrees with the requirements in the minimum
clearance section of this guide. Wood joists must be
sound and of adequate size to support 35 pounds (See
page 2, items 3 and 4).
If not already present, mount a UL listed outlet box marked
2
"Acceptable for Fan Support of 15.9 kg (35 lbs) or Less"
following the instructions provided with the outlet box. The
outlet box must be able to support a minimum of 35
pounds.
Attach hanging bracket to outlet box using screws
3
provided with the outlet box.
Canopy
Yoke cover
Motor housing
Light kit
Parts identification on assembled fan.
Ceiling fan
outlet box
Hanger
bracket
Flat washer
Spring washer
Outlet box screw
Fig. 1
Downrod
Blade
| hinkley.com |
©2023 Hinkley Lighting, Inc.
05