Advertisement
80", 56", or 32"
Hang Track
Note:*On open
wall applications
always maintain
a minimum of 1"
from the edge of
the standard to
the end of the
hang track.
Mark Hole Centers at 96"
when using a 90" Standard
to maintain 6" off the floor.
Mark Hole Centers at 84"
when using a 78" Standard
to maintain 6" off the floor.
84" using
78" standard
Standards and Track Installation
Self Drilling
DryWall Anchor
#10 x 3" Flat
Head Screw
Drill 5/32" pilot
hole into studs
for #10 x 3" Flat
Head Screws
96" using
90" standard
6"
Self Drilling
DryWall Anchor
www.sauder-closets.com
Mark all stud locations.
Adjust or cut Hang Track location to
insure maximum studs are fastened to.
Hold the Hang Track up and mark
hole centers at the listed heights.
Where there are no studs, use a
Drywall Anchor.
Hang Standards in accordance of the Shelf
width or Cabinet width being installed. Secure
base of Standards by marking hole locations,
installing Drywall Anchor or drilling 5/32" pilot
hole, and installing #10 x 3" Screw.
NOTE! Maximum unsupported width is 36"
#10 x 3" Flat
Head Screw
Note:* When
using Cabinets
and /or Shelves
side by side,
Double Standards
must be used.
Page 7
Advertisement
