Steps
1. Align and place the fan on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x5) to secure the fan to the palm-rest and keyboard assembly.
3. Connect the fan cable to the connector on the system board .
Next steps
1. Replace the
base
cover.
2. Exit
service
mode.
3. Replace the
SD
card.
4. Follow the procedure in
Heat sink
Removing the heat sink - UMA
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Enter
service
mode.
4. Remove the
base
cover.
About this task
The following images indicate the location of the heat sink and provides a visual representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
39