Installing A Lock On 24Vac Systems; Installing A Lock For High Voltage Systems - Nice HySecurity SwingSmart DC Installation And Reference Manual

Installing a MagLock or Solenoid Lock

Installing a Lock on 24VAC Systems

To install a lock for 24VAC systems, take
the following steps:
1. Connect a wire from COM on USER
1 RELAY and one 24VAC power
spade. See Figure 6-3
2. Connect a power lead from the lock to
the remaining 24 VAC power spade.
3. Connect the remaining power lead
from the lock to the NC terminal on
USER 1 RELAY.
Note:Connect to NO on USER 1
RELAY if installing a Solenoid lock.
4. Set the User Relay function in the
Installer Menu to RL1 - 6. Refer to
Setting the User Relay Function in the
Installer Menu.
Installing a Lock for
High Voltage
Systems
To install a lock on higher voltage systems (115V or
230V), take the following steps:
1. Connect one lead of the power supply to one lead
of the lock's coil. See Figure 6-4.
2. Connect the other lead of the lock's coil to NO on
USER 1 RELAY.
Note:Connect to NC on USER 1 RELAY if installing
a maglock.
3. Connect the COM on USER 1 RELAY to the
second lead wire in the power supply (115V or
230V).
4. Set the User Relay function in the Installer Menu
to RL1 - 6. Refer to
6-4
COM
COM
COM
COM
COM
COM
COM
COM
STOP
OPEN
CLOSE
OPEN
P ARTIAL
EYE
OPEN
EYE
CLOSE
EXIT
LOOP
BLOCK
EXIT
IN OBS
LOOP
OUT OBS
LOOP
CENTER
LOOP
EDGE
EYE
COM
+ 24 V
EMERG
OPEN
Setting the User Relay Function in the Installer
SwingSmart DC Installation and Reference Manual
2
Connect to COM on
USER 1 RELAY.
SHOW
LEDs
Figure 6-3.
115VAC
230VAC
POWER SUPPLY
High voltage
High voltage
Menu.
A ach the power lead from the lock
to the 24VAC power spade.
3
1
Connect the power lead from the lock's coil to:
NC for a MagLock
NO for a Solenoid lock
1
Lock
2
3
NO
COM
USER 1 RELAY
Figure 6-4.
Revision E