Table of Contents
Advertisement
ESIE16-02K
|
Part 5. Appendix
5.1.2. Outdoor unit
5.1.2.1. Facility setting for outdoor split units
This function is designed for facilities such as equipment or computer rooms. It is never to be used in a residence or office where people occupy the space.
Cutting jumper 6 (J6) on the circuit board will expand the operation range down to -15°C. However it will stop if the outdoor temperature drops below -20°C and start back up once the
temperature rises again.
* Cut J6 with nippers or a similar tool
Other jumper settings
J5: No function for this unit.
J8: Cold region setting (changing the operating range from - 10°C to -15°C).
J9: No function for this unit.
J11: Protection for error memory overwrite (only to be used during development).
J12: No function for this unit.
5.1.2.2. Multi split outdoor
5.1.2.2.1 Wiring error check
This product is capable of automatic correction of wiring error.
Shortly press the "wiring error check switch" on the outdoor unit service PC board. However, the wiring error check switch will not function for 3 minutes after the safety breaker is turned
on; or depending on the outside air conditions (see note 2). About 15 - 20 minutes after the switch is pressed, the errors in the connection wiring will be corrected.
Shortly press the "wiring error check switch" again for cancellation. Wiring error check is not possible after cancellation. The safety breaker has to turn off and turn on again to restart wiring
error check.
If self-correction is not possible, check the indoor unit wiring and piping in the usual manner.
LED
1
2
3
All flashing (simultaneously)
Status
Flashing (on after another)
w (one or more LEDs 1 to 4 are ON)
Note
1.
For two rooms, LED3, 4 and 5 are not present, and for three rooms, LED4 and 5 are not present, and for four rooms LED 5 is not present.
2.
If the outside air temperature is 5°C or less, the wiring error check function will not operate.
3.
After wiring error check operation is completed, LED indication will continue until ordinary operation starts.
This is normal.
4.
Follow the product diagnosis procedures (details of product error diagnosis are listed on the back of the fight side plate).
Page 98
RA R32 Split & multi split M-Series
Figure 5-3: Jumper settings
4
5
Autonomic correction impossible
Autonomic correction completed
Abnormal stop (note 4)
Figure 5-4: Service PC board wiring error check switch location
1
1. Wiring error check switch (SW3)
Message
5.1. Field setting
31/05/21
|
Version 1.1
Advertisement
Table of Contents
Troubleshooting
