Replacing LED
Items Needed
Replacement LED (#PT33904106-1) ................. 1
Electrical Tape or Cable Ties ............ As Needed
To replace LED:
DISCONNECT MACHINE FROM POWER!
1.
Turn light seat counterclockwise to release
2.
seat and pull it down through headstock hole
(see Figure 64).
Light
Seat
Figure 64. Location of light seat.
Move light seat tabs away from LED to
3.
remove LED from light seat (see Figure 65).
Model T33903/T33904 (Mfd. Since 07/23)
Disconnect LED from wire connector shown
4.
in Figure 65 and replace with new LED.
Qty
LED
Light Seat
Figure 65. LED disconnect components.
Install new LED in light seat.
5.
Bind any stray laser module or LED wires and
6.
cords together with electrical tape or cable
ties to keep electrical components from being
caught in moving headstock parts.
Feed laser module and LED wires and cords
7.
back into headstock, install light seat in head-
stock, then turn clockwise to secure.
Light Seat Tab
(1 of 2)
Wire Connector
-45-