Grizzly T33903 Owner's Manual page 22

T33903: Place rack inside of table support
4.
bracket, mesh it with pinion, and slide bracket
over column, as shown in Figure 15.
Table Support Bracket
Column
Figure 15. Example of sliding table support
bracket and rack over column.
T33904: Place rack inside of table assembly,
mesh it with pinion, and slide table assembly
over column, as shown in Figure 16.
Table
Assembly
Figure 16. Sliding table assembly and rack over
column.
-20-
Rack
Rack
Column
Slide column collar over column with beveled
5.
edge facing down, as shown in Figure 17,
then fit beveled edge of collar over rack and
tighten set screw to secure.
Note: Do not overtighten set screw or you
may split column collar. Also make sure rack
is seated firmly between column collar and
column base.
Figure 17. Correct column collar orientation.
Install table height crank over worm shaft
6.
shown in Figure 18, then tighten set screw in
crank against flat part of shaft to secure.
Figure 18. Table height crank installed (T33904
shown).
Model T33903/T33904 (Mfd. Since 07/23)
Beveled
Edge
Table Height
Crank