Cleaning And Maintenance - Zephir ZRA1516 Instruction Manual

HOW TO USE
1. Before using the heater, make sure that it is on a flat and stable surface. Damage may occur if it is placed on an
incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-outlet with well grounded. Be sure that plug fits
firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the heater on as follow:
a. the switch I for low heat;
b. the switch II for medium heat;
c. both switches on for high heat.
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob counter clockwise until the
pilot light goes out. The thermostat can now be left at this setting. As soon as the room temperature has dropped
below the set temperature, the unit will switch itself on automatically until the set temperature has been reached
again. In this way the room temperature remains constant with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the temperature, or
counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of the heater are getting
excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug from the socket-outlet.

CLEANING AND MAINTENANCE

1. Always remove the plug from the socket-outlet and allow the radiator to cool down before clean the heater.
2. Wipe radiator with a soft damp (not wet) cloth.
Warning:
3. Do not immerse the heater in water.
4. Do not use any cleaning chemicals such as detergents and abrasives.
5. Do not allow the interior to get wet as this could create a hazard.
6. To store away the heater, wind the cable round bobbin and store the heater in a clean dry place.
7. In case of malfunction or doubt, do not try to repair the radiator yourself, it may result in a fire hazard or electric
shock.
Item Symbol
Heat output
Nominal heat P
nom
output
Minimum heat P
min
output (indicative)
Maximum P
max,c
continuous heat
output
INFORMATION REQUIREMENTS FOR LOCAL SPACE HEATERS
Value Unit
1,5 KW
0,6 KW
1,5 KW
Item
Type of heat input, for electric storage local space heaters only (select
one)
manual heat charge control, with integrated thermostat
manual heat charge control with room and/or outdoor
temperature feedback
electronic heat charge control with room and/or outdoor
temperature feedback
Unit
no
no
no