Assign; Examples Of Settings - Boss Vocal Performer VE-22 Reference Manual

Useful functions
Parameter Value
MEMORY
PREF
(PREFERENCE)*1
SYSTEM
EXP
FUNCTION VOLUME, OFF
MEMORY
PREF
(PREFERENCE)*1
SYSTEM
0–100
MIN
Not available when
FUNCTION = OFF.
0–100
MAX
Not available when
FUNCTION = OFF.
*1: These are system parameters that globally apply to all
memories. You can't change the settings on a per-memory basis.
5 .
Follow the steps in "Saving a memory (MEMORY
WRITE)" (p. 11) to save the settings you edited.
* Your settings are lost if you switch between memories or turn
off the power without performing the MEMORY WRITE (p. 11)
operation.

ASSIGN

You can specify in detail the parameters controlled when you operate
the pedal switches on this unit or an external controller connected to
the CTL 1,2/EXP jack.
This setting lets you switch up to eight parameters at once by
operating an external controller, which is useful when you're playing
live.
These settings can be saved for each memory.
* Your settings are lost if you switch between memories or turn
off the power without performing the MEMORY WRITE (p. 11)
operation.
You must perform a MEMORY WRITE after you change the
settings.

Examples of settings

This example shows how to configure the following two parameters
to switch at the same time when the pedal is in memory mode and
you press the [HARMONY] pedal.
Turn chorus ON and raise the echo volume
1. Set the effect (CHORUS) to "ON".
2. Set the echo LEVEL to "80".
16
Getting ready
Explanation
Used as a function
for each memory.
1 .
Used as a global
function for all
memories.
Specifies the
function.
Used as a function
for each memory.
Used as a global
function for all
memories.
Sets the value
used when the
expression pedal
2 .
is at the minimum
setting (all the way
pressed down with
your heel).
Sets the value
used when the
expression pedal
is at the maximum
setting (all the way
pressed down with
your toes).
3 .
4 .
5 .
Press the [É] switch and [Ç] switch simultaneously
to enter memory mode.
Configure the effect settings.
2-1 .
Press the [EFFECT] knob twice to open the
EFFECT screen.
2-2 .
Set SW to "OFF" and TYPE to "CHORUS".
Press the [EXIT] button to return to the play screen.
Configure the echo settings.
4-1 .
Press the ECHO knob twice to open the ECHO
screen.
4-2 .
Set SW to "ON" and LEVEL to "50".
Press the [EXIT] button to return to the play screen.