Xerox DocuColor 3535 Quick Start Manual page 7

7 Preparing to print
T F
O CONNECT THE IERY TO A NETWORK
1. Prepare a network node for the Fiery.
2. Route the cable to a location near the copier where the Fiery will be installed, and
attach the cable to the network interface of the Fiery.
For more information, see Chapter 1 of the
3. Print a copier Test Page to verify the copier is functioning normally.
For detailed instructions, see the
Configuring the network server
If you require a network server, you must configure that server to provide client access
to the Fiery as a color printer. To configure a network server in a Windows or UNIX
network environment, see the
2000 (using TCP/IP) networks, the network servers must be configured for printing to
the Fiery before you configure Fiery network settings in Setup. For more information,
see the Configuration
Setting up the Fiery from the Copier Control Panel
Setup configures the Fiery to communicate with other devices and manage print jobs.
You must perform Setup the first time you turn on the Fiery after new system software
is loaded, or any time Server software is reinstalled. Initial Setup must be performed at
the Fiery Copier Control Panel (for Network Setup) and from Command WorkStation
or WebSetup (for Server Setup and Printer Setup).
Perform the following Setup options in the order listed:
•
Network Setup
the Fiery.
•
Server Setup
•
Printer Setup
This is the minimum setup required to enable your Fiery to begin printing.
N :
OTE
To configure network settings in Setup, you need a live network connection so the
Fiery can query the network for zones, servers, and server-based queues.
Configuration
Configuration
Guide.
—specifies all the active network systems that transmit print jobs to
—specifies system options.
—specifies how print jobs and queues are managed.
Configuration Guide.
Guide.
Guide. For Novell and Windows NT/