Kohler 32495 Installation Manual

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips &
Flathead Screwdriver
FIXTURE INSTALLATION
Remove the fixture and parts bag(s) from the carton. Put them onto a and
1.
soft cloth to protect finish. Confirm all parts are included.
2. Loosen screws (G) and then remove mounting plate (B) from canopy (F).
3. Attach mounting plate (B) onto outlet box with screws (D). Ensure ground
screw (C) is attached to mounting plate (B).
4. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in outlet
box with wire nut (A) or fasten onto ground screw (C) on mounting plate.
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wire to the white wire in outlet box with wire nut (A). Wrap
the wire connector with electrical tape so that the tape seals the end of wire
nut (A). See diagram 1.
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten the
fixture black wire to the black wire in outlet box with wire nut (A). Wrap the
wire connector with electrical tape so that the tape seals the end of wire
nut (A). See diagram 1.
7. Insert quick connector (E) into the opposing quick connector end.
8. Tuck wires carefully inside outlet box. Attach the canopy (F) onto mounting
plate (B) with screws (G).
9. Install glass shade (I) onto socket sleeve by turning it until the connection is
tight.
10. NOTICE: DO NOT exceed recommended wattage. Rated Max 60W, E12 Type B.
(Bulb(s) not included).
11. Install bulb to the socket (H).
12. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY. Clean glass
with a mild soap.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Wire
Electrical Current
Cutter/stripper
Electrical
Tape
Tester
SKU#32495
Electrical tape
Approved fastener
(Wire nut)
Diagram 1
1479871-2_A