Hisense AHM-100HCDSAA Installation & Maintenance Manual page 63

Model(s):
Air-to-water heat pump:
Water-to-water heat pump:
Brine-to-water heat pump:
Low-temperature heat pump:
Equipped with a supplementary heater:
Heat pump combination heater:
Parameters shall be declared for
Parameters shall be declared for
Item
Rated heat output (*)
Declared capacity for heating for part load at indoor temperature 20°C
and outdoor temperature Tj
Tj = – 7 °C
Tj = +2 °C
Tj = +7 °C
Tj = +12 °C
Tj =bivalent temperature
Tj = operation limit temperature
Tj = – 15 °C (if TOL < – 20 °C)
Bivalent temperature
Cycling interval capacity for heating
Degradation co-efficient (**)
Power consumption in modes other
than active mode
Off mode
Thermostat-off mode
Standby mode
Crankcase heater mode
Other items
Capacity control
Sound power level, indoors/outdoors
Annual energy consumption
Contact details
Qingdao Hisense Hitachi Air-conditioning Systems Co., Ltd.
No. 218, Qianwangang Road, Economic and Technological Development Zone, Qingdao, China
(*) For heat pump space heaters and heat pump combination heaters, the rated heat output Prated is equal to the design load for
heating Pdesignh, and the rated heat output of a supplementary heater Psup is equal to the supplementary capacity for heating sup(Tj).
(**) If Cdh is not determined by measurement then the default degradation coefficient is Cdh = 0,9.
Technical parameters
Outdoor unit: AHW-160HC(E)DS1
Indoor unit: AHM-160HC(E)DSAA
yes
no
no
no
yes
no
Medium temperature application.
warmer climate conditions.
Symbol Value Unit
Prated 13.8 kW
Pdh - kW
Pdh 13.85 kW
Pdh 8.84 kW
Pdh 3.99 kW
Pdh 8.84 kW
Pdh 13.85 kW
Pdh - kW
Tbiv 7 °C
Pcych - kW
Cdh 0.9 -
0.005 kW
POFF
0.002 kW
PTO
0.005 kW
PSB
0 kW
PCK
variable
44/67 dB
LWA
4448 kWh
QHE
53
TECHNICAL PARAMETERS
Item
Seasonal space heating energy efficiency ηs
Declared coefficient of performance or primary energy ratio for
part load at indoor temperature 20 °C and outdoor temperature Tj
Tj = – 7 °C
Tj = +2 °C
Tj = +7 °C
Tj = +12 °C
Tj =bivalent temperature
Tj = operation limit temperature
Tj = – 15 °C (if TOL < – 20 °C)
Operation limit temperature
Cycling interval efficiency
Heating water operating limit temperature WTOL
Supplementary heater
Rated heat output (*)
Type of energy input
Rated air flow rate, outdoors
Symbol Value Unit
162 %
COPd - -
COPd 2.38 -
COPd 3.44 -
COPd 5.28 -
COPd 3.44 -
COPd 2.38 -
COPd - -
TOL 2 °C
COPcyc - -
- °C
Psup 0.0 kW
Electric
4200 m3/h