DSC PC5020 Manual

Wiring trikdis gt+ cellular communicator and programming the panel

Hide thumbs Also See for PC5020:

• The communicator should be installed and maintained by qualified personnel.

CAUTION

• Prior to installation, it is advised to read full device installation manual carefully in order to

avoid mistakes that can lead to malfunction or even damage the equipment.

• Disconnect the power supply before making any electrical connections.

• Changes, modifications or repairs not authorized by the manufacturer shall void your rights

under the warranty.

Schematics for wiring the communicator

to the security control panel

Following the schematics provided below, wire the communicator to the control panel.

EGND T-1 R-1

TIP RING

DSC PC5020

COM

Wiring Trikdis GT+ Cellular Communicator and

COM

GRN YEL BLK RED

PGM

trikdis.com

PC5020

Programming the Panel

- +

-BELL+

AUX

Table of Contents

Need help?

Do you have a question about the PC5020 and is the answer not in the manual?

Page 1 • Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty. Schematics for wiring the communicator to the security control panel Following the schematics provided below, wire the communicator to the control panel. EGND T-1 R-1 TIP RING GRN YEL BLK RED -BELL+ DSC PC5020 trikdis.com...
Page 2 PC5020 Wiring Trikdis GT+ Cellular Communicator and Programming the Panel DSC PC5020 panel do not need to be programmed. LED indication of communicator operation Indicator Light status No connection to cellular network Yellow blinking Connecting to cellular network NETWORK Green solid with yellow blinking Communicator is connected to cellular network.
Page 3 Enter the IMEI number of Select security company Press "DSC" button the communicator Step 5 Step 6 Step 7 Step 8 Enter "Object ID" and Wait while the Press "PC5020" Press "Add to Protegus2" "Module ID". Press "NEXT" configuration is written trikdis.com...
Page 4 PC5020 Wiring Trikdis GT+ Cellular Communicator and Programming the Panel Setting up the GT+ communicator with the app Step 9 Step 10 Step 11 Step 12 Enter system "Name". Wait 1 minute and press Press "Skip" Press on system Press "Next"...