Advertisement
Quick Links
IMPORTANT NOTICE
HD44 Series and HD88 Series
INTRODUCTION
In some installation scenarios, an audio/video source component (such as a cable box or DVD
player) may fail to work properly with distribution products or even a display. The problem is often
related to the source component's video outputs exhibiting too much DC offset voltage on the signal
line. The result of poor DC offset voltage
conditioning on the output often results in color
problems such as color bleeding, picture clarity,
definition, and stability issues.
VS100 DC BLOCKER
To resolve this issue, use a Xantech 'VS100'
Video Stabilizer DC Blocker. The 'VS100' is
placed in between the source component output
and the input to the distribution product. Packaged
in convenient inline dongles, the 'VS100' requires
no additional cables or power connections. A
'VS100' DC Blocker set needs to be connected
between each source component with a DC offset
issue and its corresponding input on the HD88 or
HD44.
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Installation Instructions, Blocker Notice, HD44/88
© 2008 Xantech Corporation, Document #08905208A
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Xantech
Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.
08905208A
Advertisement
