Front Panel - LevelOne FHU-1604TXDS User Manual

100BASE-TX Class II standard. Normally, the distance between two Class II hubs
is 5 meters. This special ability allows user to use the bridging port as daisy-chain
port(just like as 10BASE-T) and to expand the network size more flexible and the
cabling system is similar to 10BASE-T.

Front panel

The following figure shows the front panel of 100Mbps Stackable Ethernet Hub
FHU-1603TXS Front Panel
FHU-2403TXS Front Panel
FHU-3203TXS Front Panel
All ports' Transmit and Receive lines are crossed within the hub. A
l
10/100BASE-TX port must be internally cross-wired to let you connect an
end node using straight-wired cabling.
For FHU-1603TXS/FHU-2403TXS/FHU-3203TXS Series
A special push-bottom switch is for setting the corresponding RJ-45 connector
into "Normal" or "Up-link" mode. For example, 16-port dual speed hub, the 12
port can be act as normal port or "Up-ink" port by pushing the switch. The
"Up -link" port is used for connection another hub through an ordinary straight-
wired twisted-pair cable by running one end of straight cable to "Up -link" port and
the other end to another hub's station port.
On the front panel, there are several LED indicators for monitoring the device itself,
and the network status. At a quick glance of the front panel, the user would be able
to tell if the product is receiving power; if it is monitoring another hub or
10
th