Panasonic FP7 Series User Manual page 56

3.5 Wiring Connector-type I/O Unit(Push-In Connector)
Wiring
Follow the procedure below when wiring.
Wiring precautions
● Do not damage the core when stripping off the covering material.
● Do not apply stress to the wires after wiring.
● Do not solder the core. Soldering the core may cause it to disconnect due to vibration.
1.
Strip off the covering material from the wire
10 mm
2.
Attach the pole terminal to the core part. Do not twist the core when attaching.
3.
After attaching the pole terminal, pressure-weld using the dedicated pole terminal pressure-
welding tool.
4.
After pressure-welding, insert the wire into the product.
3-16 WUME-FP7DIO-05