Table of Contents
Advertisement
ATTACH THE MOUNTING
B3.
PLATE TO THE WALL
Attach the plate to the wall using toggle
bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate
2
through the holes designated to go into
drywall and reattach the toggle wings to
(19 mm) onto each bolt.
To use toggle bolts:
Spacing for Toggles
More Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Place the mounting plate against the wall
3
and insert the toggle wings into the holes
in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the bottom of the mounting
plate touch the bottom of the cabinet when
pushed flush against the wall and that the plate is
properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the
wall.
4
Tighten all bolts. Pull the plate away from the
wall to help tighten the bolts.
B4.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support
screws and a hole large enough for the power
cord to fit through.
Installation Instructions
⁄
3
"
4
Bolt End
EN-17
•
Read the instructions on the TOP
CABINET TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions
on the TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when
drilling holes in the cabinet bottom.
B5.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
1 Remove and save screw that holds
blower motor to microwave.
Blower Motor
Motor Screw
Carefully pull out the blower unit. The
2
wires will extend far enough to allow
you to adjust the blower unit.
Before: Fan
Blade Openings
Facing Forward
End A
Roll the blower unit 90°
3
Before Rotation
Back of
Microwave
Back of
Microwave
Blower
End B
After Rotation
Back of
Microwave
Advertisement
Table of Contents
