Table of Contents
Advertisement
Using Weights
•
Install weights to improve balance. You can add or
remove weights to create optimized performance
under different operating conditions and for your
preference.
•
Add or remove weights 1 at a time until you
achieve the desired handling and balance.
•
Refer to the Operator's Manual of attachments for
recommended weights.
Note:
Contact an Authorized Service Dealer to order
a weight kit.
WARNING
Excessive weight changes can affect the
handling and operation of the machine.
This could cause serious injury to you or
bystanders.
• Make weight changes in small increments
only.
• Evaluate the machine after each weight
change to ensure that you can operate the
machine safely.
After Operation
After Operation Safety
General Safety
•
Always shut off the machine, remove the ignition
key, wait for all moving parts to stop, and allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the PTO whenever you are transporting
or not using the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
23
Advertisement
Table of Contents
