Toro GrandStand Manual

GrandStand
All GrandStand
Ensure the traction rollers are lubricated at the new
interval. Keep this addendum with your Operator's
Manual.

Lubricating the Machine

Service Interval: Every 200 hours/Yearly (whichever
comes first)—Lubricate the traction
rollers (more often in dirty or dusty
conditions).
Lubricate the traction rollers with a dry lubricant
(PTFE).
Figure 1
Adjusting the Speed Control
Lever
1. Disengage the PTO, move the right side motion
control lever to the neutral position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Move the HOC lever to the 1 inch height-of-cut
position (lowest position) (Figure 2).
4. Move the speed control lever to the fast position
(Figure 2).
5. Hold the motion control levers fully forward.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
™ Mowers
™ Mowers
1. Motion control levers fully
2. Speed control lever in fast
6. Locate the cable and cable clamp under the frame in
7. Loosen the cable clamp and pull the cable towards
8. Tighten the cable clamp but not so tight that it
1. Clamp
Register at www.Toro.com.
Figure 2
forward
position
front of the left wheel, as shown (Figure 3).
rear of the unit until tight (Figure 3).
restricts the travel of the cable (Figure 3).
Figure 3
Form No. 3361-684 Rev A

Addendum

3. HOC lever in the 1 inch
height-of-cut position
(lowest position)
2. Cable
Original Instructions (EN)
Printed in the USA.
All Rights Reserved