Table of Contents
Advertisement
• The appliance does not drain the water.
• The drum does not turn.
• The appliance makes an unusual noise
because of the blockage of the drain
pump.
• The display shows the alarm code
WARNING!
• Do not remove the filter while the
appliance operates.
• Do not clean the pump if the water in
the appliance is hot. Wait until the
water cools down
WARNING!
Each time you carry out the special
programme CLE to remove fluff, clean
the drain filter afterwards.
Proceed as follows to clean the pump:
1. Open the pump cover.
1
2. Place a suitable bowl below the drain
pump access to collect the water that
flows out.
3. Open the chute downwards. Always keep
a rag nearby to dry up any water spillages
when removing the filter.
42
ENGLISH
.
2
4. Turn the filter 180 degrees in anti-
clockwise direction to open it, without
removing. Let the water flow out.
5. When the bowl is full of water, turn the
filter back and empty the container.
6. Repeat the steps 4 and 5 until the water
stops to flow out.
7. Turn the filter anti-clockwise to remove it.
1
8. If it is necessary, remove fluff and objects
from the filter recess.
9. Make sure that the impeller of the pump
can rotate. If it does not rotate, contact
the Authorised Service Centre.
2
Advertisement
Table of Contents
