Table of Contents
Advertisement
A correct adjustment of the appliance
level prevents the vibration, noise and
the movement of the appliance when in
operation.
When the appliance is installed on a
plinth, use the accessory described in
chapter 'Accessories'. Read carefully the
instructions supplied with the appliance
and with the accessory.
5.4 The inlet hose
1. Connect the water inlet hose to the back
of the appliance.
2. Position it toward left or right depending
on the position of the water tap.
45º
45º
20º
20º
Make sure that the inlet hose is not in
vertical position.
3. If necessary, loose the ring nut to set it in
the correct position.
12
ENGLISH
4. Connect the water inlet hose to the cold
water tap with 3/4" thread.
WARNING!
The inlet water shall not exceed 25 °C.
CAUTION!
Make sure that there are no leaks from
the couplings.
Do not use an extension hose if the inlet
hose is too short. Contact the service
centre for the replacement of the inlet
hose.
5.5 Water-stop device
The inlet hose has a water stop device. This
device prevents water leaks in the hose
because of its natural ageing.
The red sector in the window «A» shows this
fault.
A
If this occurs, close the water tap and contact
the authorized service centre to replace the
hose.
5.6 Water drainage
The drain hose should be positioned at a
height of not less than 60 cm and not more
than 100 cm from the floor.
Advertisement
Table of Contents
