Table of Contents
Advertisement
The door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
Touch the Départ/Pause button: the
appliance performs only the draining
phase.
The appliance empties the water out
automatically after approximately 18
hours.
8.5 Taches/Prélavage
Press this button repeatedly to activate one of
the two options.
The relevant indicator goes on in the display.
• Taches
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in
the appropriate phase of the washing
programme.
This option can increase the
programme duration.
This option is not available with a
temperature lower than 40 °C.
• Prélavage
Use this option to add a prewash phase at
30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust , mud and other solid particles.
This option can increase the
programme duration.
These two options cannot be set
together.
18
ENGLISH
8.6 Départ Différé
With this option you can delay the start of a
programme in a more convenient time.
Tap on the button repeatedly to set the
required delay. The time increases by steps
of 30 minutes up to 90' and from 2 hours up
to 20 h.
After starting the cycle by the means of the
Départ/Pause button, the display shows the
selected delay time and the appliance begins
the countdown.
8.7 Time Manager
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly soiled,
it may be advisable to shorten the washing
programme. Touch this button once to
decrease the duration.
• In case of smaller load, touch this button
twice to set an extra quick programme.
On the display the programme duration is
adjusted accordingly.
When this button is set, the led above the
button is on.
This option can also be used to shorten
the steam programme duration.
8.8 Antifroissage
This option adds a short anti-crease phase at
the end of the programme.
This phase reduces fabric creasing and
facilitates the fabric ironing.
When this option is set, the led above the
button is on and then blinks during anti-
crease phase.
This option can increase the programme
duration.
By touching any button the anti-crease
movements stop and the door unlocks.
To interrupt the anti-crease phase, you can
also:
Advertisement
Table of Contents
