Table of Contents
Advertisement
1-3. Error Indication
1-3. Error Indication
When an error or warning occurs, PFV-SP series and HKSP-R80 operate as follows.
. The output of 4-pin (BOARD ERROR OUT) or 5-pin (BOARD WARNING OUT) of the STATUS
OUT connector of the connector panel of the PFV-SP series becomes high impedance (low level in
normal operation).
. The STATUS indicator of the PFV-SP series blinks in red (error) or in green (warning).
. The STATUS indicator of the indicator panel of the CPU-355 board blinks in red (error) or in green
(warning).
. The error code and error symbol are displayed on the status indicator of the indicator panel of the CPU-
355 board alternately.
When there is no error, "R80" is displayed on the status indicator. On similar occasions, when the BZR-
IF810 is installed in the HKSP-R80, "810" is displayed. (The STATUS indicator lights in green.)
n
For the error message displayed on the personal computer (terminal emulator) connected to the
REMOTE3 connector or DATA connector, refer to the system setup manual supplied with the HKSP-
R80.
Error code
Error code
Error symbol
E.27
SBUS
E.50
BT
E.80
MEM
E.FE
PG
E.FF
CN
Warning code
Error code
Error symbol
W.60
REF
(Not displayed)
1-2 (E)
Description
Connection error of S-BUS
Error of lithium battery (BT501) for
backup
Error of the checksum of ROM (IC602
to IC605) or writing error of RAM
(IC503 to IC506)
n
When restarting the HKSP-R80 after
rewriting the application software, this
error code is displayed.
However, it does not indicate
abnormal state.
System does not start for a reason
that the program is not downloaded
correctly.
Connector board is not installed in the
correct slot or no connector board is
installed in the slot.
Description
Although S803-1 is set to OFF
(SYNC), no reference signal is input.
Although the CPU-355 board for
backup is installed, it does not start.
Remedy
Check the connections among the
devices in the S-BUS link, then attach a
75 Z terminator.
Replace the lithium battery. (Refer to
Section 1-5.)
Replace the corresponding IC.
Download the program again.
Install the connector board in the slot
correctly.
Remedy
Input the reference signal to the
connectors (REF IN A/B) of the PFV-SP
series correctly and set the reference
channel used in S802-7 (REF A/B)
correctly. In the case that the reference
signal is not used, set S803-1 to ON
(ASYNC).
Replace the CPU-355 board for backup.
HKSP-R80
Advertisement
Table of Contents
