Subaru BRZ 2016 Service Manual page 164

PERIODIC MAINTENANCE SERVICES
(9) Adjust the oil as soon as the proper temperature for oil amount adjustment is reached.
CAUTION:
Always be sure to adjust the ATF when at the proper temperature.
Lower than proper temperature
Only the [ ] indicator light is illuminated
3) Remove the overflow plug and check the oil amount when at the proper temperature for oil amount inspec-
tion.
• The oil amount is proper when fluid flows out of the overflow tube and then the flow of the fluid is thin.
• If fluid does not flow out of the overflow tube, fill through the refill hole until fluid flows out of the overflow
tube. The oil amount is proper when the flow of the fluid is thin.
4) Install the overflow plug using a new gasket.
CAUTION:
Tighten the overflow plug with the ATF temperature at 43°C — 47°C (109.4°F — 116.6°F) (indicator
lamps [ ] and [ ] are illuminated simultaneously).
Tightening torque:
20 N·m (2.1 kgf-m, 27.3 ft-lb)
5) Perform final tightening of the refill plug using a new O-ring.
Tightening torque:
39 N·m (4.0 kgf-m, 27.3 ft-lb)
6) Install engine under cover No. 2.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
7) Install engine under cover No. 1.
Tightening torque:
M10: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
M12: 30 N·m (3.1 kgf-m, 22.1 ft-lb)
8) Lower the vehicle.
9) Turn the ignition to OFF.
Automatic Transmission Fluid
Proper temperature
[ ] and [ ] indicator lamps are illumi-
nated simultaneously
PM-74
Higher than proper temperature
Only the [ ] indicator light is illuminated
PM-00628