Table of Contents
Advertisement
Problem and alarm code
The appliance does not fill with
water.
i10
The display shows
The appliance does not drain the
water.
i20
The display shows
The anti-flood device is on.
i30
The display shows
Malfunction of the water level de‐
tection sensor.
i41
The display shows
Malfunction of the wash pump or
the drain pump.
i51
The display shows
i5A
i5F
-
.
The temperature of the water in‐
side the appliance is too high or
malfunction of the temperature
sensor occurred.
i61
The display shows
Technical malfunction of the ap‐
pliance.
iC0
The display shows
The level of water inside the ap‐
pliance is too high.
iF1
The display shows
The appliance stops and starts
more times during operation.
The programme lasts too long.
The displayed programme dura‐
tion is different than the duration
in the consumption values table.
The remaining time in the display
increases and skips nearly to the
end of programme time.
22
ENGLISH
Possible cause and solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
i11
this information, contact your local water authority.
or
.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the interior filter system is not clogged.
•
Make sure that the drain hose has no kinks or bends.
.
•
Close the water tap.
•
Make sure that the appliance is correctly installed.
.
•
Make sure the baskets are loaded as instructed in the user manual.
•
Make sure that the filters are clean.
•
Switch the appliance off and on.
i44
-
.
•
Switch the appliance off and on.
i59
-
or
•
Make sure that the temperature of the inlet water does not exceed
60°C.
•
Switch the appliance off and on.
i69
or
.
•
Switch the appliance off and on.
iC3
or
.
•
Switch the appliance off and on.
•
Make sure that the filters are clean.
•
Make sure that the outlet hose is installed at the right height above
.
the floor. Refer to the installation instructions.
•
It is normal. It provides optimal cleaning results and energy savings.
•
If the delayed start is set, cancel the delay setting or wait for the end
of the countdown.
•
The pressure and the temperature of the water, the variations of the
mains supply, the options, the quantity of dishes and the degree of
soil can change the programme duration.
•
This is not a defect. The appliance is working correctly.
Advertisement
Table of Contents
