Table of Contents
Advertisement
5.3.4 Alarm
5.3.4.1 Motion Detection
Click on Motion in Motion Detection menu.
Enable:
Sensitivity:
Set the motion detection sensitivity level ( 1~ 8)
The higher the level the less pixel colour changes needed to record
Alarm Out:
Latch Time:
Set the latch time for the alarm trigger (Default = 5 secs)
Post Recording: Set the post recording time for the alarm i.e after alarm triggers.
Send Email:
Enable Record:
Refresh:
Applies default settings
Save:
Saves Motion Detection settings.
Clear:
Clears all motion settings.
All:
Sets whole picture for motion detection. (Complete area red colour)
Click in box to enable motion detection.
Click in box to enable alarm output.
Click in box to enable Email (Email settings are required)
Click in box to enable Alarm Record.
(Default = 5 secs)
33
Advertisement
Table of Contents
