Related Manuals for Harper 14A01
Summary of Contents for Harper 14A01
- Page 1 TURBO VAC 60RH Serial Number: 14A01 + Part # 301026 OPERATOR’S & PARTS MANUAL Turbo Vac TV60R 1-2024...
- Page 2 Turbo Vac TV60R...
- Page 3 © 2022 Harper Industries, Inc. The Harper and Goossen names are registered trademarks of Harper Industries, Inc. All other brand and productnames are trade- marks or registered trademarks of their respective companies. Turbo Vac TV60R...
-
Page 4: Limited Warranty
Harper Industries or at the manufacturing plant in Harper, KS. A part will be replaced after inspection discloses it to have been defective. This warranty does not apply to defects caused by damage or unreasonable use (includ- ing failure to provide reasonable and necessary maintenance, or by performing functions without genuine Harper Turbo Vac accessories) while in the possession of the consumer. - Page 5 PARTS SECTION Table of Contents Hydraulics TV60RH Hydraulic Schematic......Machine Hydraulics.......... Hydraulic Res., Valve, and Drive-TV60RH..OPERATOR SECTION To the Owner or Operator..........Hydraulic Valve..........Warranty Statement............Remote Table of Contents............Wiring Schematic TV60RH....... Specifications..............Remote and Receiver........Feature Introduction Broom TV60RE............
-
Page 6: Specifications
2250 lbs – 1023 kg Weight NOTE: Following publication of this manual certain changes in standard equipment and/or options may have occurred that would not be included in these pages. Your Harper/Goossen dealer is the best source for up-to-date informaion. Turbo Vac TV60R... -
Page 7: Feature Identification
Feature Identification MANUAL & BALL REMOTE BROOM HITCH CRONTROLS Hydraulic Pump – The hydraulic pump on Air Return – The air return allows air to be the TV60RH is directly attached to the tractor recirculated, significantly reducing dust. PTO. Always connect torque chain to tractor. Hopper –... - Page 8 TV60RH - Hydraulic System Blower Motor & Flow Control Valve Hydraulic Reservoir Assembly PTO Gear Pump (unit parked) NOTE: The PTO gear pump should be stored as shown in the above photograph when the TV60RH is parked. PTO Gear Pump on Tractor PTO Turbo Vac TV60R...
-
Page 9: General Safety Guidelines
During Operation General Safety Guidelines • While operating the equipment, make sure that no foreign objects such as Equipment & Controls rocks, bottles or other hard materials • Before operating this equipment, read are in the path of the Turbo Vac. and understand the Owner’s Manual. - Page 10 • New decals may be obtained from your local Harper Dealer. Turbo Vac TV60R...
- Page 11 Replacement Parts SAFETY WARNING! Use genuine factory parts or parts with equivalent characteristics including: type, strength and material. Failure to do so may result in voidance of warranty, product malfunction or possible injury to operator and others. • Replace locknuts and locking screws if they can be tightened without considerable resistance for several turns before they are completely tight.
-
Page 12: Setup And Operation
tractor, other power cords may be or- Specific Safety Guidelines dered (p/n 935017). Attach the unit to a tractor with a PTO. TV60RH Be sure that the Turbo Vac is level with • Avoid wearing loose clothing to pre- the ground. (Refer to Adjustments vent it from getting caught in the PTO section.) drive. - Page 13 Note: The BLOWER switch is not used on Starting Operation the TV60RH remote control. SAFETY WARNING! Move the throttle on the tractor to the Before operating the Turbo Vac, perform “SLOW” position and disengage the PTO lever to turn off the blower. the daily inspection as described in the Shut off the tractor engine and allow Service &...
- Page 14 • The jack stand should be up, with the Towing wheel in stow location whenever the SAFETY WARNING! Turbo Vac is connected to a tow vehi- The Turbo Vac does not meet highway cle. safety codes. Tail lights, turn signals and safety chains must be attached before towing on public roadways.
- Page 15 Adjustments POSSIBLE HITCH TV60RH Hydraulic Controls MOUNTING • The hydraulic flow control and pressure LOCATIONS relief are set at the factory, and should not require adjustment. Broom Height • The broom height should be adjusted so that the broom barely touches the grass.
- Page 16 Remote and Receiver 4. Sleep time programming complete. System Operation Indicator Lights Press and hold the power button the trans- The transmitter has two LED indicators, the mitter until both LEDs turn on, then release. red BATTERY/DIAGNOSTIC indicator and The greed LED will flash rapidly when com- the green TRANSMIT indicator.
- Page 17 7. Replace the cover on the receiver. Vibration: 3G to 200 Hz Outputs: 5A maz each (20A system max) Specifiactions RF Transmit power (EIRP): 10 mW RF Frequency: 902-928 MHz Operating temperature - Radio: -40C to +85C Battery life (min): 30 hours continuous POWER LIFT HOP LOWER HOP...
-
Page 18: Service And Maintenance
• Broom lift (2) Service & Maintenance SAFETY WARNING! Before servicing or inspecting the Turbo Vac, make sure the power source is shut off and all moving parts have stopped. SAFETY WARNING! Disconnect the spark plug wire or the negative battery cable to prevent the engine from being turned on. - Page 19 • Replace the breather (Part no.822018) TV60RH Hydraulic Oil Reservoir • The TV60RH is equipped with a HY- whenever the element is replaced. DAC hydraulic oil filter assembly that is designed for a long service life. • Monitor the needle in the filter indicator daily.
- Page 20 Hydraulic System Remote Control • The hydraulic system of the TV60RH • If the remote control transmitter or is filled at the factory with Crown receiver should ever be replaced, the AW 46 hydraulic oil that has an ISO dip switches must be set so that the of 46.
- Page 21 Blower Liner • Regularly inspect the blower liner in the blower housing for wear. • If the blower liner wears excessively, damage may result to the blower housing. • The blower liner is a wear item and is not covered under warranty. •...
- Page 22 Return Air Screens • To set door prop, pull the door open and • The return air screens do not require insert prop into the pre-cut hole in door. cleaning on a regular basis. • Material that sticks to the screens dur- ing operation will fall off when the blower is stopped.
-
Page 23: Standard Torque Chart
TV60RH Service Schedule Daily Check hydraulic oil level…………........Crown AW46 Check hydraulic oil filter indicator…………………………… Change filter element when needle is in red portion of gauge.* Check hydraulic oil cooler…………………………………… Clean as necessary. Visually inspect belts, bolts, fittings, and hoses ………….. Tighten or replace if necessary. -
Page 24: Optional Equipment
Never allow the brush to rest com- Contact your Harper Dealer for more pletely on the ground during operation. information about optional equipment, or see the Harper Industries website at: SAFETY WARNING! www.harperindustries.com The Turbo Vac should never be trans- ported with the fence brush in operating position. - Page 25 Turf Sweeper Parts TV60RH Turf Sweeper Turbo Vac TV60R...
- Page 26 Table of Contents PARTS SECTION Hydraulics TV60RH Hydraulic Schematic......Machine Hydraulics.......... Hydraulic Res., Valve, and Drive-TV60RH..Hydraulic Valve..........Remote Wiring Schematic TV60RH....... Remote and Receiver........Broom Broom Wheel............ Broom Lift............Broom............... Finger Rotor Kit..........Finger Rotor Assembly........Air Return............Air Return Screens........... Fan Housing.............
- Page 27 Turbo Vac TV60R...
- Page 28 Turbo Vac TV60R...
- Page 29 Turbo Vac TV60R...
- Page 30 Turbo Vac TV60R...
- Page 31 Turbo Vac TV60R ii 1.3...
- Page 32 Turbo Vac TV60R...
- Page 33 Turbo Vac TV60R...
- Page 34 Turbo Vac TV60R...
- Page 35 Turbo Vac TV60R...
- Page 36 Turbo Vac TV60R...
- Page 37 Turbo Vac TV60R...
- Page 38 Turbo Vac TV60R...
- Page 39 Turbo Vac TV60R...
- Page 40 Turbo Vac TV60R...
- Page 41 Turbo Vac TV60R...
- Page 42 Turbo Vac TV60R...
- Page 43 Turbo Vac TV60R...
- Page 44 Turbo Vac TV60R...
- Page 45 Turbo Vac TV60R...
- Page 46 Turbo Vac TV60R...
- Page 47 Turbo Vac TV60R ii 4.2...
- Page 48 Turbo Vac TV60R...
- Page 49 Turbo Vac TV60R...
- Page 50 Turbo Vac TV60R...
- Page 51 Turbo Vac TV60R...
- Page 52 Turbo Vac TV60R...
- Page 53 Turbo Vac TV60R ii 4.6...
- Page 54 Turbo Vac TV60R iii 4.6...
- Page 55 NOTES Harper Industries, Inc. Telephone: 620-896-7381 151 E. Highway 160 Toll-Free: 800-835-1042 Harper, KS 67058 Fax: 620-896-7129 Website: www.harperindustries.com E-mail: info@harperindustries.com Turbo Vac TV60R...
- Page 56 © 2013 Harper Industries, Inc. All rights reserved. Printed in U.S.A. Turf Sweeper Turbo Vac TV60R...