TKH SiQURA PD1022v2 Quick Start Manual

PD1022v2
2MP Network PTZ Dome Camera
Quick Start Guide
Unpack
Gland Sets
Screws(4x) &
Plastic Screw
Anchors (4x)
Camera Unit
Security Torx
Subject to modification. Actual product and accessories may differ in appearance.
SD Card & Default
Remove the silicon plug and
unscrew 4x to remove cover
Silicone Plug
Decorative Rim
5
Memory Card Slot
Remove memory card cover
and insert Micro
SD/SDHC/SDXC up to
128GB
Memory Card Cover
© TKH Security B.V. 2023 | Version 2 (20230209) | PD1022v2-QS-EN
Combi-connector 3-
pin(2x), 4-pin(1x)
14-pin Alarm/Audio
I/O terminal block
Quick Start Guide
Find additional manuals, the
datasheet, the EU Declaration of
Conformity, and the latest firmware
for this product at:
tkhsecurity.com
Installation Notices
Caution installation shall be performed by qualified
personnel only. Installation shall be in accordance with
local procedures. The camera contains batteries.
Battery replacement shall not be applied in view of the
risk of explosion. Dispose of used batteries according to
the instructions.
For "PoE" input connection, use only with UL listed
I.T.E. with "PoE" output. Description for the "PoE" is
intended to be connected to not exposed (outside plant)
networks or equivalent statement in installation
instructions.
Default Button
Press the button with a proper
tool for at least 20 seconds to
restore the system.
Figure 3 – Position of default button
Connectors
1
Power (DC12V)
Ground
Alarm in
2
Alarm Out
3
Audio I/O
RJ-45 Port
4
802.3at PoE+
Figure 1 Camera Connectors
Camera Cabling
No. Connector Definition
1 Alarm I/O Alarm I/O connection
2 Audio I/O Line In and Line Out connection
RJ-45 Port
(Contact Siqura for
3 For network and PoE connections
a compatible PoE
injecter.)
4 Power(DC 12V) Power Connection
To restore camera to factory defaults, power
5 Reset Button
up with Reset button pressed for at least 10s.
Insert the SD card into the card slot to store
6 Micro SD Card Slot videos and snapshots. Do not remove the SD
card when the camera is powered on.
Table 1 Connector definition