Troubleshooting - Foster FHC540XM Operation Instructions Manual

English
To reset the temperature setting recorded in THI and TLO, access the information menu by pressing
to display the value, whist keeping button
completed.
To check the LOC status, move through to LOC, press
keys accessible.
Checking the temperature Set Point.
Press Button for at least half a second, to display the setpoint value.
By keeping pressed, use buttons
minimum SPL and the maximum SPH limit).
When Button is released, the new value is stored.
Press display shows OFF
This indication is displayed while the unit is not operating but with mains power supplied to the unit.
In case of the cabinet not being used for a long period, it is recommended that the cabinet is switched off
and the mains lead is unplugged at the socket.

Troubleshooting

Alarms/Warnings
Symbol
DO
Door open alarm
OFF Controller in stand-by
E1 Probe T1 failure
Before contacting your supplier please make sure that:
a. The plug has not come out of the socket and the mains power supply is on i.e. is the controller
illuminated?
b. Check to see if the unit is in standby
c. The fuse for the cabinet is intact
d. The products are placed in the unit correctly
If the reason for the malfunction cannot be identified, disconnect the electrical supply to the unit and
contact your supplier. When requesting a service call, please quote the model and serial number which can
be found on the silver label located on the inside of the unit (starts 212 and is nine numbers long).
7
pressed, press
or
Reason Symbol
LO
simultaneously for resetting to be
to display status - YES to lock keys. - NO to leave
to set the desired value (adjustment is within the
Reason
HI
Cabinet high temperature alarm
Cabinet low temperature alarm