Table of Contents
Advertisement
Mains connection
The mains connection must be carried out by an expert
electrician. The VDE-regulations and the valid pre-
scriptions by the local power supply boards have to be
complied with.
According to existing mains voltage the appliances are
to be connected in correspondence with the following
diagram of connections.
Prior to connection it should be checked whether the
voltage stated on the type plate - i.e. the nominal vol-
tage of the appliance - is identical with the prevailing
mains voltage. The type plate ist located on the lower
oven frame at the left side and is visible after opening
of the oven door.
The heating element voltage amounts to 230 V ~. The
appliance will also perfectly perform with the former
mains voltage of 220 V ~.
The mains connection must be carried out in a way that
an all-pole isolating device is existing with a contact
opening of at least 3 mm, e.g. LS-automatism, earth-
leakage circuit-breaker or fuse.
Awire of type HOSVV-F or of higher rating is to be used
as supply cable.
The mains terminal
is located at the back of the
appliance behind a covering slide.
The protective conductor is to be connected to terminal
. The bridges of the terminal board are to be chan-
ged accordingly, if need be.
The cable connections have to be established as
prescribed and the terminal screws be firmly tigh-
tened.
Afterwards the supply cable has to be secured by strain
relief device.
Oven with cord and plug :
put the plug into a socket, installled by an electric ex-
pert.
A
After connection to the power supply all heating
elements are to be switched on shortly at maxi-
mum setting one after another, in order to check
the operability.
Fixing in the kitchen furniture
back of appliance
AC 230
1. remove rubber plugs
2. inscrew the oven
3. put back rubber plugs
y
32
Advertisement
Table of Contents
