Table of Contents
Advertisement
30
Dr iv er in f ormation
sys tem
To sto re ma x imum speed
.. Turn off the ignit ion.
.. Briefly press the button in the instrument
cluster¢ page 29, fig. 26 . The odometer
and the digital clock are now illuminated .
.. Press the button for at least 2 seconds. The
currently stored maximum speed appears in
the display or the crossed out symbol for
warning threshold 2, if no maximum speed
was set previous ly.
.. Press the fu nction selector switch in the
wiper lever @ ~ fig. 2 7 up or down to
change the set value. Values run up or down
in steps of 6 mph (10 km/h) .
To delete maximum speed
.. Turn off the ignit ion.
.. Briefly press the button in the instrument
cluster~ page 29, fig. 26. The odometer
and the digi t al clock are now illuminated .
.. Press the button for at least 2 seconds. The
currently stored maximum speed appears in
the disp lay.
.. Press the
l ~ R_E_S-E
T ~ I
button in the w iper lever
@ ¢fig. 2 7 until the crossed out speed
warning symbol for warning threshold 2 ap-
pears in the display.
A few seconds after the adjustment is com-
pleted, the illumination for the odometer and
the dig ita l clock will go out.
{D)
Tips
This war ning threshold can also be con-
trolled through the trip computer
¢
page 25, Navigating the menu.
Warnings
and symbols
Red symbols
A red symbol means DANGER.
.. Pull of the road and stop the vehicle.
.. Turn off the engine .
.. Check the malf unct ioning system. Contact
your authorized Audi dealer or a qualified
workshop for assistance.
-
USA models:
Malfunction in the brake sys-
tern
~page32
•
Canada models:
BRAKE
Malfunction in the brake sys-
tern
~page32
•
Engine coolant level too low/
COOL ANT
engine coolant temperature
too high
~page32
Engine oil pressure too low
OIL PRES- ¢page 33
SURE
When a red symbol appears, a warning tone
will sound three times in succession. The sym-
bol cont inues to flash unt il the malfunction
has been repaired. If there is more than one
malfunction, the symbols appear one after
the other for about two seconds.
@
Tips
- The message for a malfunction can be
shown by pressing on the left knob.
- During route guidance on vehicles with a
navigation system, the warn ing symbol
is shown in the field above.
Yellow symbols
A yellow symbol means WARNING.
II
Low f uel level
~page33
-
•
Check engine oil level
~page33
•
Engine oil sensor malfunction
¢page33
IJ
Worn brake pads
¢page33
•
USA models :
Speed warni ng 1
~page34
'
Advertisement
Table of Contents
