Table of Contents
Advertisement
12. Press and release the learn button on the
garage door opener motor.
.. Note:
once the button is pressed, there are
30 seconds
in which to initiate the next
step .
13. On the Homel ink® keypad inside the vehi-
cle, firmly press and hold the Homelink ®
button previously programmed in phases
1 and 2 for two seconds and release. Re-
peat t his sequence
twice .
.. Some vehicles may req uire the press/hold/
release sequence up to three times to com -
plete the training process .
.. Homelink ® should now activate your rolling
code equipped device.
If the
5
minute time limit is exceeded, the
emergency flashers will flash one time
to in-
d icate that the process has been terminated.
In this case, repeat steps 4 through 9 .
If the emergency flashe rs do not flas h three
times (after about 15 - 60 seconds), program-
ming was not successful. In this case, repeat
steps 4 through 9.
Remote control units for garage door openers
in Canada are set to stop transmitting radio
frequency signals after two seconds. This time
may not be sufficient for the Homelink ® sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above .
Operating the Homelink ® transmitter
Applies to vehicles: with Home link® univers al remote
control
The Homelink ® transmitter works in the
same manner as the original handheld re-
mote control that came with the system.
en
~-----------------~
0
t
Fig. 105
Overhead console: Home l ink® keypad
"'
..
Iii ~
:::~,
~:::
Homelink
®
97
.. Press the appropriate programmed button
Q), @)
or @ to activate the desired remote
contro l function
~
A
in General informa-
tion on page 95 .
Reprogramming a single button
Applies to vehicles: with Hom elink ® universal remote
contr ol
A HomeLink® button can be reprogrammed
individually without affecting the other but -
ton allocations.
Programming the overhead keypad
.. Press the appropr iate Homelink ® button un-
til the ind icato r light begins flashing slowly .
Programming the bumper mounted trans
mitter
1. Hold the
original remote control at a d is-
tance between 0-5 in. (0-13 cm) from the
bumper below the appropriate headlight
for yo ur vehicle (use the shortest distance
possible) .
2. Aim the remote control just below the
driver side
headlight.
3.
Press and hold the activation button on
the remote control.
4. The emergency flashers will flash
three
times
(after about 15- 60 seconds) when
the programming is successful. Now re-
lease the button on the remote control.
.. If the device ut ilizes a rolling code, please
follow phase 3 of
c:>
page 96, Programming
the Homelink ® transmitter for rolling code
programming.
This procedure will cause the existing pro-
gramming on the Homelink ® button to be
erased!
Advertisement
Table of Contents
