Table of Contents
Advertisement
Use of jumper cables
Make sure t o connect the jumper cable
clamps in exactly the order described below'
Fig. 162
Luggage compa rtme nt : connec tors for a
charge r and jump start cab les
Fig. 163
Jump sta rt using the batte ry in anot her vehi-
cle : A - Female socket , B · Discharge
The batte ry is located in the luggage compart-
ment ¢
page 185.
The front lid can be opened
in an emergency
C?
page
43 .
Do
not
connect the negat ive cable directly to
the negative termina l on the battery. Connect
it to a j ump start pin instead ¢
fig.
162.
Connect the posit ive cable (red) to the
positive t ermin al
1.
Connect one end of the red jumper cable
¢
fig.
163
(D
to the positive te rm inal of
d ischarged battery @ .
2. Connect the other end of the red jumper
cab le to the positive termina l @ of the
booster battery @ .
Connect the negat ive cable (black ) t o the
negati ve t erminal
3 . Connect one end of the black jumper ca-
ble @ to the negative terminal of the
booster battery @ .
What
do I d o now ?
221
4.
Secure the other end to the jump start pin
@ for the discharged battery @ .
Starting the engine
~
Start the engine of the veh icle providing as-
sistance and al low it to run at idle.
~
Now sta rt the engine of the vehicle with the
discharged battery .
~
If the engine does not start: Stop trying af-
ter 10 seconds and then try again after
about 30 seconds.
~
Disconnect the cable while the engine is
running in exactly
reverse
order to that de -
scribed .
The ba t tery is ven t ed to the out side to prevent
gases from entering the vehicle interior . Make
sure that the jumper clamps are well connect-
ed with their
metal parts in full contact
with
the battery term inals .
.&,
WARNING
To avoid serious personal injury and dam-
age to the veh icle, heed all warnings and
instructions of the jumper cable manufac-
turer . If in doubt, call for road service.
- Jumper cables m ust be long enough so
that the vehicles do not touch.
- When connecting jumper cables, make
sure that they cannot get caught in any
mov ing parts in the engine compart-
ment.
- Before you check anything in the engine
compartment,
always read and heed a ll
WARNINGS¢
page 175, Working in the
engine compar tment.
(D
Note
Improper hook-up of jumper cables can ru-
in the generator .
- Always connect POSITIVE(+) to POSI-
TIVE(+), and NEGATIVE( - ) to NEGATIVE
(- ) ground post of the battery manager
control unit.
- Check that all screw plugs on the battery
cells are screwed in firm ly. If not, tighten
plugs prior to connecting clamp on nega-
-
tive battery terminal.
.,..
Advertisement
Table of Contents
