Sliders; Winter Slider; Summer Slider; Border Control - Dcm 2500 PRO Manual

SLIDERS

WINTER SLIDER

For the full spreading width (6 m): push the application hole to fully open (the adjuster is
not pulled out).
To halve the spreading width (e.g. for pavements and paths): pull out the adjuster.
Use the summer slider for granulated deicing salt. Set the left adjuster halfway closed for optimum
results.

SUMMER SLIDER

Different settings are possible for the summer slider as well as a border control (see next point).
By opening and closing the adjusters on the left and the right, the spreading distribution can be
adjusted for optimal accuracy of your spreading.
Large/heavy materials
e.g. fertilisers

BORDER CONTROL

With the border control, you can prevent material from ending up in your
borders or flower beds, on your paths or your driveway. By activating the
border control, the left hand side of the spreading pattern will be cut off.
This means that the material will no longer be spread on the left side of
the spreader, while application is maintained to the centre and right side of
the spread pattern.
Pushing in the border control slider (as indicated by the arrow in the figure)
will close of one side of the spreader. To deactivate the border control, pull
out the border control slider again.
Small/light materials
e.g. grass seeds
EN
47