Align the holes on the handle bar (part 6) and on the back
stand (part 5).
Insert the four remaining bolts (part 22) through the holes on
the handle bar (part 6) and the back stand (part 5). Tighten
the M6x65 bolts (part 22) with the M6 lock nuts (part 26).
Take the bent end of the control rod (part 2) and insert it
through the hole at the back of the small V-shaped metal
plate (pivot bracket). It should lock into place.
Take the other end of the control rod (part 2) and align it
with the hole on the control lever (part 7). Push the lever all
the way to 20 and then hand tighten the screw.
Make sure the application hole at the bottom of the hopper
is fully open. You should see all the holes or the hole of the
slider. Insert both agitators (part 8), with the smaller one
going under the larger one.
42