ASSEMBLY
TOOLS
1
Spanner
Pair of pliers
Philips screwdriver
STEP-BY-STEP INSTRUCTIONS
Not included.
1
40
Place the hopper body (part 10) on a table so that the
gearbox is pointing upwards. Take the bolts out of the main
frame (part 4) – you will use these to attach the back stand
to the hopper body and the main frame. Remove the nuts
from the bolt ends.
Take the back stand (part 5) and align it with the holes on
the main frame (part 4). Insert the four bolts (part 21) in the
holes available.
Use a spanner to tighten the lock nuts (part 26). The back
stand (part 5) should now be securely attached to the hopper
body and the main frame (part 4).
Take the pneumatic wheels (part 19) and slide them over the
axles on each side of the main frame (part 4). You will also
need the two cotter pins (parts 24 and 25).