Dcm 2500 PRO Manual page 45

Once the slider (part 16 or 18) you no longer want to
use has been removed, push the alternative slider into
the grooves on the bottom of the hopper body
(part 10).
EN
The slider should be secured, in a horizontal position under
the hopper body. It should slide smoothly in and out the
grooves .
2
Pull the slider out a little so that there is space to insert the
pivot rod (part 3) back into the pivot bracket and slider
(part 16 or 18).
Push the bottom end of the pivot rod (part 3) into the hole at
the top of the slider and secure with the R-pin (part 23).
4 washers are fixed on the underside of the hopper body. The slider should be pressed in the grooves thus created.
2
45