Table of Contents
Advertisement
9. Replace three screws (M1.6x2.5) that secure the camera and display-assembly cable holder to the system board.
10. Connect the camera cable and the display cable to the system board.
11. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board and tighten the three
captive screws (M1.6x2).
Next steps
1. Install the
base
cover.
2. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2 2230 solid-state drive
4. Remove the battery.
5. Remove the fans.
6. Remove the
heat
sink.
About this task
The following image indicates the connectors and components on your system board.
Figure 36. System-board connectors
1. Wireless card
3. Display-assembly cable connector
5. Left-speaker cable connector
7. Haptic-module cable connector
9. Battery cable connector
11. Right-fan cable connector
13. Power-button and fingerprint-reader cable connector
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
or
M.2 2280 solid-state drive
computer.
computer.
from M.2 slot, whichever is applicable.
2. Camera-assembly cable connector
4. Capacitive touch-panel cable connector
6. Left-fan cable connector
8. M.2 solid-state drive slot
10. Keyboard-daughterboard cable connector
12. Right-speaker cable connector
Removing and installing Field Replaceable Units (FRUs)
55
Advertisement
Table of Contents
