Adaptive Cruise Control - Ford TERRITORY 2020 Owner's Manual

Changing the Set Speed
• Press and release RES/+ or SET/-.
When you select km/h as the display
measurement in the information
display the set speed changes in
approximately 2 km/h increments.
When press continuously set speed
changes in approximately 5km/h
increments / decrements.
•
Press the accelerator or brake pedal
until you reach the desired speed. Press
and release RES/+ or SET/-
• Press and hold RES/+ or SET/- .
Release the control when you reach
the desired speed.
Note: If you accelerate by pressing the
accelerator pedal, the set speed will not
change. When you release the
accelerator pedal, your vehicle returns to
the speed that you previously set.
Canceling the Set Speed
Press and release CANCEL or tap
the brake pedal. The set speed does
not erase.
Resuming the Set Speed
Press and release RES/+.
Switching Cruise Control Off
Press and release the OFF button, when
the system is in standby mode or switch
the ignition off.
Note: You erase the set speed when you
switch the system off.
Guidelines To Activate Cruise
Control
1. Press "ON/OFF".
2. Vehicle speed is greater than or equal
40 km/h.
3. Press "SET/-".
4. Do not apply the brake.
5. The speed is within a certain range
(40 km/h-140 km/h).
Territory (CF4) Philippines, Vehicles Built From: 25-05-2020, EN, First Printing
Cruise Control
97
(If Equipped)
Automatic Cruise Control
Cancellation
1. Tap the brake pedal.
2. Shift to "P" or "N".
3. System failure.
4. Exceeds speed limit above 140 km/h.
5. Drops speed limit below 40 km/h.
6. System battery voltage is low.
ADAPTIVE CRUISE
CONTROL
Function Description
Adaptive cruise control detects a vehicle
ahead using the sensor installed in the
front bumper lower grille, that way the
vehicle can travel at the defined cruise
control speed.
When there is a vehicle ahead,
with less speed, the vehicle will
automatically maintain the distance from
the other vehicle. Before
using the function, please read and
familiarize yourself with all information in
this chapter.
WARNING
In some traffic, road, and
weather conditions, the sensor
detection may not work
correctly. Please turn off the
function and drive carefully under
critical conditions.
In environments where sensor
l
signals are intensely reflected
(e.g. multi-storey car parks, tunnels,
etc.), sensor performance may be
reduced. Please cancel or turn off
the function.