Advertisement
INSTALLATION INSTRUCTIONS
TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle escutcheon with the Flange washer onto the all
thread. Press them firmly against the plate and mark the position.
- Remove the handle trim assembly and all thead and cut off the
excess thread.
-Inset the broach extension onto the valve.
- Insert the Handle onto the broach extension. Measure the excess between
the handle and thetrim plate. Take off the handle and cut the excess stem.
- Reinsert the handle onto the stem.
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
WARMER
HOT
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
ILLUSTRATION C
WARM
COLD
PM-280 - SERVICE VALVE (OPTIONAL)
FILTER SCREEN - TE012
VALVE CARTRIDGE - TE010
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
FLANGE WASHER
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
Handle Trim Assembly
Trim Plate
Escutcheon
All Thread
Broach Extension
Lock Nut
Lock Plate
Diverter Knob
Trim Plate Grommet
Diverter Rod
PM-012 - LOCK NUT
PM-011 - ALL THREAD
0 3
Advertisement
