Audi Q7 2014 Owner's Manual page 14

Table of Contents

Advertisement

12
Instruments
and warning/indicator
lights
Speedometer with odometer
The speedometer shows you the vehicle
speed, and the odometer shows you how
many miles (kilometers) you have driven.
Fig. 5 Instrument cluster Odometer and reset button
The odometer and trip odometer are located
inside the speedometer.
- USA mode ls - Miles
- Canada models - Kilometers
You can switch the display from miles to kilo-
meters and vice versa via the MMI. You can
find out more in the MMI manual.
Lower odometer
The low er odometer shows the total number
of mi les (kilometers) driven.
Upper odometer (trip odometer)
The upper odometer shows the t ota l number
of mi les (kilometers) driven since you last re-
set the odometer to zero. You can use this od-
ometer when you want to keep track of how
many miles (kilometers) you have driven for a
single tr ip or errand. The last digit indicates
1/10 of a mile (100 meters).
You can reset the trip odometer to zero by
pressing the Reset button
~o.
Malfunction message
If there is a ma lfunction somewhere in the in-
strument cluster, dEF will appear in the trip
odometer and will stay on. Contact your au-
thorized Audi dealer to have the problem cor-
rected.
(D
Tips
- When you open t he driver door, the time,
date and odometer are disp layed for an
additiona l 30 seconds.
- You can also call up the display with the
I
CHECK
I
button
c>
page 12 while the ig-
nition is switched off.
Fuel gauge
The fue l gauge only works when the ignition is
on.
When the needle reaches the reserve mark,
the
c>
page 35
00]
symbol appears in the in-
strument cluster display as well as the mes-
sage
Please refuel.
This message is meant to
remind you to
refuel.
The total tank capacity of your vehicle is listed
in .:> page 315 .
@
Note
Never run the tank completely dry. An ir-
regular supply of fuel can cause engine
misfiring and fuel could enter the exhaust
system. The catalytic converter could then
overheat and be damaged.
~
button
Fig. 6 CHECK butto n in the i nstrument cluster
The
!CHECK
I
button performs the follow ing
funct ions:
Switching on the clock and odometer
With the ig nition turned off, the odometer
reading and the dig ita l clock with date display ..,_

Advertisement

Table of Contents
loading

Table of Contents