Winbook x1 User Manual page 98

X series manual w/no OS 9/5/01 2:20 PM Page 98
Series
User's Manual
Exit Saving Changes: This item will save all the changes that you made
during this session and exit the Setup program. Your system will then
reboot with the new settings. If you notice any problems with the operation
of your system, you will need to re-enter the Setup program and correct
settings that might be causing the problems.
Exit Discarding Changes: This item will abandon all changes that you
have made to the Setup program in this session and exit the Setup program.
Load Setup Defaults: Restores all the values to the default settings that
were in place when you received your WinBook notebook. You can now
save these changes and exit or return to the other menus to make additional
changes.
Discard Changes: Restores all values to the settings that were in place
before you entered the Setup program. You can now save these changes
and exit or return to the other menus to make additional changes.
Save Changes: This item allows you save the changes without exiting
the Setup Program. All changes made will be saved, but you can continue
to make changes in the other menus before exiting.
Battery Calibration: This item allows you to start a special program
designed to optimize battery performance. It must be performed when
installing a new battery. The battery will be fully discharged. Then the
computer will automatically be turned off. This process might take as long
as two hours. You will then have to fully charge your battery. Performing
this routine on a regular basis will help your battery retain its optimal
charge level. Note: the system fan will turn on during calibration to keep
the system cooled and help optimize calibration.
When you activate this utility, you will be asked if you want to perform
the calibration. Type "Y" to begin the calibration. You will then be asked
to disconnect the AC power so that the battery can be drained. Type "Y"
again to proceed with the calibration. Once the battery has drained and
the computer has shut down, you can reconnect the AC power and start
up your system.
98