Winbook SI User Manual page 22

indicate that the battery is charging. The light shuts off to indicate that the
battery is fully charged.
The power LED indicates the power status of your WinBook notebook.
-A green light indicates that the system is powered on, either using the
AC adapter or the battery.
-An amber light indicates that the battery has reached a low power level.
-A blinking green light indicates a critically low battery level or that the
unit is Suspended to RAM or to Disk.
Power On
The first time you use your WinBook notebook, use your AC power adapter.
This will allow your battery to fully charge. It is recommended that you
then allow the battery to fully discharge and recharge three times. This will
help calibrate the electronics that monitor and maintain the battery charge.
After those three full discharges, you can partially discharge or charge your
system as your use demands, although you should allow a full discharge/
recharge periodically to help optimize battery life. See Chapter Three for
more information on conditioning and maintaining your battery efficiency.
Connect your AC Adapter to your system. Connect the power cord to the
adapter and connect the cord to a wall outlet or power strip. Slide the dis-
play panel release latch to the right and gently lift the display panel until
it is fully vertical. Press the power button on your computer to initiate
a boot of the system.
Your system should pass right through the memory tests and setup to start
loading Windows.
Chapter 1: Getting Started
The sharpness of the screen
will vary with your viewing
angle. Try moving the dis-
play panel slightly forwards or
back to find the optimal contrast.
1.13