Table of Contents
Advertisement
M
"'
0
..J
"".
rl
I.O
Loosening
• Install the
wheel bolt wrench
ove r the
whee l bolt and push it down as far as it will
go.
• Take tight hold of th e
end
of the wrench
handle and turn the whee l bolts
counter-
clockwise
abou t
one single
t urn in t he di rec·
tion of arrow
c::>
fig. 263 .
Tightening
• Install the
wheel bolt wrench
over the
wheel bolt and push it down as far as it will
go .
• Take tight hold of the
end
of the wrench
handle and turn each wheel bolt
clockwise
until it is seated .
&
WARNING
- Do not use force or hurry when changi ng
a whee l · you can cause t he vehicle to slip
off t he jac k and cause serious personal
injuries .
- Do not
loosen the wheel bolts
more than
one turn
before you raise the veh icle with
the jack. - You risk an injury.
(j)
Tips
If a wheel bolt is very tight, you may find it
easie r to loosen by carefully pushing down
on the end of the wheel bolt wrench with
one foot only .
As you do so, hold on to the
car to keep yo ur balance and take care not
to slip.
Raising the vehicle
The vehicle must be lifted with th e jack first
before the wheel can be removed .
"'
rl
"'
Fig. 264 Sill pane ls: markings
rl
What
do I do now?
309
Fig. 265 Sill: posit ioning the jack
• Activate t he vehicle jack mode* (only
veh icles with Adaptive Air Suspension)
c::>
page
161 .
• Engage the
parking brake
to prevent your
vehicle from rolling unintentionally
• Move the
selector lever to position P.
• Find the
marking
(imprint) on the sill t hat is
nea rest the whee l that will be changed
c::>
fig. 264.
Behind the marking, there is a
lifting point
on the sill for the jack.
• Turn the
jack
located under the lifting point
on the sill to raise the jack until its arm @
c::>
fig .
265
is located under the designated
plastic mount
c::>
.&.
c::> Q ) .
• Align the jack so that its arm @
c::>
fig. 265
engages in the designated lifting point in
the door s ill and th e movable base ® lies
flat on the ground. The base @ must be
ver-
tical
under the lifting point @ .
• Wind the jack up further until the flat t ire
comes off the ground
c::>
.,&.
Position the jack
only
under the designated
lifting points on the sill
c::>
fig. 264.
There is
exactly
one
locat ion for each whe el. The jack
must not be positioned at any other location
c::>
.&.
c::> Q).
An
unstable surface
under the jack ca n cause
the vehicle to slip off the jack. Always provide
a firm base for the jack on the ground . If nec -
essary place a sturdy board or similar s upport
under the jack . On
hard, slippery surfaces
(such as tiles) use a rubber mat or similar to
prevent the jack from slipping
c::>
,&. .
.,,.
Advertisement
Table of Contents
