Audi Q7 2015 Owner's Manual page 161

M
"'
0
..J
"".
rl
I.O
"'
rl
"'
rl
emphasis on comfort are se lected in this
mode.
- Automatic lowering:
When a speed of
about 75 mph (120 km/h) is exceeded for
more than 30 seconds, the vehicle is auto-
matically lowered by 0.6 inch (15 mm) to
low level .
- Automatic raising: The vehicle is automati-
cally raised to
normal level
again, if the
speed falls below about 44 mph (70 km/h)
for a period of 2 minutes . The vehicle is
raised immediately when speed falls below
about 22 mph (35 km/h) .
Offroad
Select the offroad mode when you have to
travel over poor quality sections of road (e.g.
trails). In th is mode, the vehicle is raised to
high level 1, and damp ing characteristics for
poor road stretches are selected . When
sw itch ing to offroad mode , the Adaptive Air
Suspension ind icato r appears automat ically in
the ins t rument cluster display ¢ page 160.
The offroad mode can only be activated at
speeds below 37 mph (60 km/h) . Offroad
mode ends automatically and the automatic
mode is activated when a speed of approxi-
mately 50 mph (80 km/h) is exceeded.
Lift
Select the lift mode when except ionally high
ground clearance is needed at a reduced
speed. In this mode, the veh icle is raised to
high level 2.
When switching to lift mode , the
Adaptive Air Suspension indicator appears au-
tomatically in the instrument cluster display
¢ page 160.
The lift mode can be act ivated only at speeds
below 12 mph (20 km/h). When a speed of
about 25 mph (40 km/h) is exceeded, the sys-
tem automatically leaves lift mode and the
offroad mode is activated. The instrument
cluster display automat ically switches the dis-
play to Adaptive Air Suspens ion to indicate re-
duced ground clearance .
Adaptive Air Suspension 159
MMI settings
Applies to vehicles: wit h Adaptive Air Suspension
Driving modes are adjusted in the MMI and
the current vehicle level is displayed .
Fig. 189 MMI Display: Sett i ngs
Fig. 190 MMI Displ ay: Sett ings
The ign it ion must be switched on to set the
driving modes.
1-
Select:
!CAR !
function button .
Raising and lowering
If the arrow
(D
¢ fig . 189 is white or if the ar-
rows
(D
blink ¢ fig . 190, the vehicle is being
raised .
If the arrow @ i=> fig . 189 is white or if the ar-
rows
(D
point downward and blink ¢ fig. 190,
the vehicle is being lowered .
The respective arrow stays on/blinks until the
level change is complete . The time used for a
level change can vary, depending on the cur-
rent driving conditions .
Displaying the vehicle level
The current vehicle level is shown with seg-
ments filled out in the segment display @ . If
only the bottom segment is filled out, the ve-
hicle is at highway level. If all segments are
IJJ>-