Advertisement
(4)
Use the paper feed key and the paper rewind key to feed the leading edge of the paper
along the guideline.
Feed the leading
edge of the paper
;
-
.
=
=
/along
this guideline.
(
_ @t
p
AN
/é
f
—
=
®
When
using sheet paper, keep the paper roll inside the paper case with the cover closed.
If the
cover tends to open during operation, simply remove the paper roll from the case.
®
Paper which curves may cause dots or lines to be inadvertently plotted.
Use only paper which
is straight and which does not curve.
®
Plotting quality will suffer if the paper is not perfectly square or if the edges of the paper are
uneven.
So make sure the paper is square and recut it if necessary.
®
|f improperly
inserted
paper falls down as shown
below on the left, the surface of the paper
may rise and cause dots or lines to be inadvertently plotted.
Try to position the unit as shown
below on the right to prevent this.
Paper
)
D
S—
'@
[:_\N\\\\A\\\fifl
&\Frlm\\ill
X
O
Incorrect
Correct
2.
Inserting Roll Paper
1)
Set the paper select lever at the "'Roll Paper" position.
2)
Open
the roll paper cover by pressing it as shown
below.
When
using roll paper, keep the
cover open.
|f you plot while the cover is closed, the paper may catch between the cover
and the unit and cause improper plotting.
3}
Cut the leading edge of the roll paper with scissors to make it straight.
4)
Slide the paper roll stem inside the paper roll and insert the roll into the paper case.
5)
Feed the leading edge of the paper into the roller just as sheet paper is fed.
Then press the
paper feed key to advance the paper.
Advertisement
