Advertisement
®
|f the number of the letters exceeds the limit for letters to be plotted on one line, the scissoring
function is used at this position.
®
The character scale, alternate character scale and color setting specified in the TEXT mode are
also effective in the Graph mode.
Note:
(1)
The following
commands are effective both in the TEXT
mode and in the GRAPH
mode.
ESC+ "?"" +"a"" to ""o"
(character scale setting)
ESC + 0" to '3"
(color setting)
ESC + "a"
(TEXT mode)
ESC + ""b"
(GRAPH mode)
When
the command
ESC
+ ""a'' is performed,
the value of the Q equation
in the Q
Instruction
is set at 0.
This sets the pen
at the left margin which then becomes the
home, or origin. position.
The L Instruction remains effective.
(2)
Data reading
® | eading blanks (**
') are ignored.
®
A comma
(,) or CR code marks the end of each set of data.
When characters other
than numbers are read, all such values are omitted until the next comma or CR code
appears.
Example:
D
—1356.
21,
20,
.......
{
1
(3)
TEXT/GRAPH
setting commands are effective only after a CR or LF code.
Ignored
(5)
The values that can be specified in M, D, R or J Instructions are between —999 and
+999.
But if you input more than one R or J Instruction, values between —2048 and
+2047 can be specified.
If values outside of these ranges are input, the plotter returns to its initial state just as it
does when the reset button is pressed.
23
Advertisement
