Electronic Speed Limiter; Speed Warning System - Audi A4 2012 Owner's Manual

Table of Contents

Advertisement

I n order to make an accurate diagnosis, the
stored data can only be displayed using spe-
cial diagnostic equipment (generic scan tool
for OBD).
I n order to connect the special diagnostic
equipment, push the plug into the Data Link
Connector (DLC). The DLC is located to the
right of the hood release
c:>
fig. 23.
Your authorized Audi dealer or qualified work-
shop can interpret the code and perform the
necessary repair.
Electronic
speed
limiter
Your vehicle may be factory equipped with
tires that are rated for a maximum speed of
130 mph (210 km/h) . This is less than the
maximum speed of your vehicle. To reduce the
risk of sudden t ire failure and loss of control if
t he vehicle is operated at excessive speeds,
your vehicle also has an electronic speed lim it -
er. The electronic speed limiter prevents your
vehicle from going faster than the tire speed
rating. For more informat ion
c:>
page 258 .
If the engine contro l unit receives fa ulty vehi-
cle road speed signals, the Malfunction Indi-
cator Lamp (MIL)
¢1111ij)
will illum inate. If t his
occurs, contact the nearest authorized Aud i
dealer for assistance.
A
WARNING
Always observe the posted speed limits
and adj ust you r speed to suit prevailing
road, t raff ic and weather conditions. Never
drive your vehicle faster than the maxi-
mum speed rating of the t ires insta ll ed.
Speed
warning
system
Overview
The speed warning system helps you to keep
your driving speed below a set speed limit.
The speed warning system wa rns if the driver
exceeds a previously stored maxim um speed.
A warning tone will sound as soon as the vehi-
Dri v er information
di s pla y
2 7
cle speed exceeds the set speed by about
3 mph (3 km/h). At the same time, a warning
symbol appears in the display. The symbo l's
appearance might be different in some mod-
els.
The speed warning system has one or two*
warning thresholds that function independ-
ently of each other and that have somewhat
different purposes:
Speed warning
1
You can use speed warning 1 t o set the maxi-
mum speed while you are driving. This setting
will remain in effect until you turn off the ign i-
tion, assuming that you have not changed or
reset the setting.
The .
(USA mode ls)/ .
(Canada models)
speed warning symbo l in the warning 1 dis-
play appears when you exceed the maximum
speed. It goes out when the speed falls below
the stored maximum speed.
The speed warning symbol will also go out if
the speed exceeds the stored maximum speed
by more than about 2S mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted.
Setting speed warn ing 1 c:> page 28 .
Speed warning 2*
Stor ing warning 2 is recommended if you al-
ways want to be reminded of a certain speed,
for example when you are traveling in a coun-
try that has a general maxim um speed limit,
or if you do not want to exceed a specified
speed for winter tires.
The .
(USA models)/ .
(Canada models)
speed warning 2 symbol appears in the dis-
play when you exceed the stored speed li mit.
Unli ke warning 1, it will not go out unt il the
vehicle speed drops below the stored speed
limi t .
Setting speed warn ing 2 c:> page 28 .

Advertisement

Table of Contents
loading

Table of Contents