Speed Limiter (Pit Limiter/Full Course Yellow/120 Limiter); Display Alarms And Shift Lights - Audi RS 3 LMS DSG User Manual

Notes:

The FCY speed can be selected between the following speeds: 40, 50, 60 and 80. The speed can
only be selected with the car stopped following this process: +30 switch ON, +15 switch OFF, keep
FCY button pushed and select the speed using the gear shift paddles. The selected speed can be
seen on the AIM MXG display.

The Pit limiter speed can be selected between the following speeds: 40, 50, 60 and 80. The speed
can only be selected with the car stopped following this process: +30 switch ON, +15 switch OFF,
keep Pit limiter/Starter button pushed and select the speed using the gear shift paddles. The
selected speed can be seen on the AIM MXG display.

Although it is possible to uncouple completely the steering wheel from the column with the engine
running, it is not advisable (causes fault messages on the OBD).

Speed limiter (Pit limiter/Full Course Yellow/120 limiter)

The speed limiter system allows limiting the car speed at a preselected value. There are five possibilities:
40, 50, 60, 80 and 120 km/h. This system is recommended for the pit lane area or Full Course Yellow (FCY)
situations.
Process:
1. Select the desired speeds for each steering wheel button before starting the car and leaving the
pits. Only the FCY and Pit limiter speeds are variable, the 120 limiter cannot be changed. The
selected speeds are shown on the display.
2. Activate the desired speed limiter with the corresponding button. From this moment on throttle pedal
may be fully pressed and the speed will be limited.
3. If the car speed is over the target, the engine torque may be cut. If the speed is below the target,
torque will be applied till the speed is reached.
4. Make a short push on the selected speed limiter button on the steering wheel to deactivate the
function.

Display alarms and shift lights

Car delivery shift lights and alarms configuration:

LED 1: continuous yellow: Low oil pressure. If no red alarm follows you can continue. If alarm
disappears you can continue pushing. Check the oil level when back into the pit.

LED 1: slow blinking green: Left turn light is active.

LED 2: fast blinking red + POP UP: Very low oil pressure. Big risk to break the turbo or to damage
the engine. Audi Sport recommends slowing down and entering to the pit-lane or stopping in a safe
place.

LED 3: continuous purple: Battery voltage low warning. You can continue, check the alternator
and the alternator poly-V belt.

LED 4: continuous yellow: Fuel pressure low warning. You can continue, check the fuel level.
12